User's Manual

Appendix B - ADM Setup Screens Overview
3A2175A 67
Advanced Screen 1
This screen allows the user to set the language, date
format, current date, time, setup screens password,
screen saver delay, and turn on or off silent mode.
Advanced Screen 2
This screen allows the user to set the units of measure.
Advanced Screen 3
This screen allows the user to control the availability of a
few key system features.
• Disable Dispensing: Check this box to disable dis-
pensing from the ADM. A footswitch, gun trigger, or
other external signal will be the only means with
which to trigger a dispense.
• Disable Modifying Temp Setpoint: Check this box
to disable modifying temperature setpoints from the
Status run screen.
• Disable Operator Mode Adjustments: When this
box is checked, the user will not be able to adjust
the dispense setpoint in Operator Mode.
• Low Heater Temp Disables Dispense: When this
box is checked, the system will reject dispense
requests on system power up until all enabled heat
zones have reached their setpoint.
• High Chiller Temp Disables Dispense: When this
box is checked, the system will disable dispensing
on system power up until all enabled chiller zones
have reached their setpoint.
• Operator Mode Cavitation Alarm: Check this box
to enable cavitation alarms in Operator Mode. Clear
this box to disable cavitation alarms in Operator
Mode.
• Enable Downloading of USB Logs: When this box
is checked, USB logs will be automatically down-
loaded when a USB drive is inserted into the ADM.
• Complete Dispense with Setpoint Error: When
this box is checked, the shot will continue dispens-
ing even if the system never reaches the desired
setpoint.
The screen displays the date of the last USB log down-
load. When downloading logs, only data recorded since
the displayed date will be downloaded. To reset the date
and force a download of the USB logs in their entirety,
press the Erase Single button next to the Date of Last
Download label. The next time a USB drive is inserted
into the ADM, the complete USB logs will be down-
loaded. See Appendix F - USB Operation on page 85
for a complete explanation.