User's Manual

Troubleshootin

Booth Control

Troubleshooting

Figure 8 Booth Control

Figure 9 Bottom View of Booth Control

Table 1 . Booth Control Diagnostics

Indicator Description Diagnosis

Mix Mode (green)

LEDisonwheninMixmode.

LED blinks when in Mix Fill mode. Also blinks is Mix Idle

mode (together with Standby LED).

Purge Mode (green)

LED is on when in Purge mode.

LED blinks when a purge is needed.

Pressure Change Mode

(green)

LED blinks when in Pressure Change mode.

Alarm (red)

LED is on steady when any event has been acknowledged.

LED blinks when any event has not been acknowledged.

LED turns off after the event is cleared.

Standby Mode (green) LED is on steady when in Standby mode.

LED blinks when in Color Change, Startup, Shutdown,

Prime Pump, Fill, Calibration, Maintenance, and during

Pump Pressure Check. Also blinks is Mix Idle mode

(together with Mix LED).

Heartbeat (green)

LED blinks during normal operation.

Communication (yellow)

LED turns on when board is communication with isolation

board in electronic control.

D10

Power (green)

LED turns on when power is supplied to the board

(connector J11).

J11

Connector Power/CAN connector.

3A2800B