User's Manual

Installation
3A2894F 29
14.Connect the Catalyst (B) and
Base (A) Material Whip Hoses
to the Fluid Plate.
a. Tighten all fittings to prevent leaking.
b. Slide protective sleeve over base and catalyst
hoses.
c. MD2: Tape sleeve 8 in. (20 cm) behind the high
volume fitting to allow adequate movement of
the gun handle.
Ultra-Lite: Tape sleeve just behind manifold
block.
d. Pull the other end of the protective sleeve tightly
and secure with electrical tape.
NOTICE
Damage to the moisture-lok hoses may result in
moisture sensitive material to cure within the hose. To
avoid machine damage, avoid damaging the protec-
tive coating on the moisture-lok hoses.
Catalyst
Base
8 in. (20 cm)