Instructions-Parts Air Controls 3A0293C ENG Air controls for light and heavy duty Xtreme Sprayer carts. For professional use only. 24E025 Air Controls for Light Duty Xtreme Package Carts 24E013 Air Controls for Heavy Duty Xtreme Package Carts 100 psi (0.7 MPa, 7 bar) Maximum Working Pressure Important Safety Instructions Read all warnings and instructions in this manual and the Xtreme Packages manual. Save these instructions.
Installation Installation Prepare the Site Using the Pipe Port Inserts NOTE: Always use Genuine Graco Parts and Accessories, available from your Graco distributor. If you supply your own accessories, be sure they are adequately sized and pressure rated for your system. To open the pipe port insert (A), remove the insert pin (S) and pull insert up in direction away from pin hole. Install new insert and reinsert pin. Bring a compressed air supply line from the air compressor to the pump location.
Installation Adding a Lubricator (Accessory) B B 1 13 To add an accessory air line lubricator to the kit, you must order Part No. 244841 Lubricator Accessory Kit. 1. Remove filter/regulator from mount bracket. 2a 2. Remove the pin (B) from the outlet of the filter/regulator. FIG. 2. 4 3. Remove regulator cover. r_24e025_3A0293_4a 4. Slide the threaded end insert off (13)with outlet fittings still attached. 5.
Operation Operation Pressure Relief Procedure 1. Lock the gun trigger safety. 2. Close all bleed-type master air valves, including the bleed-type master air valve (3), supplied in your system. FIG. 2. Adjusting the Air Regulator Use the bleed-type master air valve (3) to relieve air trapped between it and the pump when the valve is closed.
Repair Repair Air Regulator Lubricator Service (Accessory) Repair Kits are available. Refer to page 6. An accessory Lubricator Kit is available. Order Part No. 244841. Repair Kits are available (refer to page 7) for an accessory lubricator. Every day, drain contaminants from the bowl before reaching the baffle level by opening the drain (D) at the bottom of the bowl (B). See FIG. 3. Clean the air filter regularly to maximize filtering efficiency and to avoid excessive pressure drop.
Repair Kits Repair Kits 116521 Air Filter/Regulator C11034 Lubricator Sight Dome Repair Kit 116670 1 Lubricate with no. 2 1 lithium-base grease. Regulator Repair Kit 116634 Bowl Repair Kit 116672 1 1 Bowl Replacement Kit 116672 TI1252A FIG. 4: C11034 Repair Kits 1 40 Micron Filter Element Kit 116635 B D TI1251A FIG.
Parts Parts 24E025 Light Duty Air Controls Ref. No. 1 2 3 4 5 6 7 8 9* 2 1 Part No. 116521 160032 113218 122327 157785 108638 100840 100960 Description REGULATOR, filter, air FITTING, nipple VALVE, ball, vented, 3/4 ELBOW, street, pipe, 90° FITTING, swivel FITTING, pipe, tee FITTING, elbow, street GAUGE, press air VALVE, safety Qty. 1 1 1 1 2 1 1 1 1 5 3 8 9* 6 5 4 7 r_24e025_3a0293a_8 24E013 Heavy Duty Air Controls 1 5 Ref. No. 1 3 5 6 7 8 9* 10 11 Part No.
Parts 244841 Lubricator Conversion Kit 2a Ref. No. 1 2 2a 2b 2c 4 Part No. Description Qty.
Technical Data Technical Data Maximum air input pressure . . . . . . . . . . . . . . . . . . . . . . . Air inlet size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Air outlet size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Gauge port size (air regulator) . . . . . . . . . . . . . . . . . . . . . Air filter element . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Maximum operating temperature 250 psi (1.7 MPa, 17.
Graco Standard Warranty Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.
