Replacement Parts • Warranty Information (USA) Product Registration (USA) To purchase parts or accessories or for warranty information in the United States, please contact us at the following: To register your Graco product from within the U.S.A. visit us online at www.gracobaby.com/productregistration. We currently do not accept product registrations from those living outside the United States of America. www.gracobaby.
Failure to follow these warnings and the assembly instructions could result in serious injury or death. This device is designed only to monitor the sounds of your child. It will not alert you to your child’s silent activities. When using the monitor, you must still provide the supervision necessary for the continued safety of your child. This product is not designed or intended for use as a medical monitor.
Battery Installation - + - - + Plug in cord + Parent Unit • The battery must be plugged into the Parent Unit before the unit will be ready for use. Remove the battery door cover on the Parent Unit with a key or flat blade screw driver. Remove the battery pack from the packaging and plug into the back of the unit. Place the battery pack into the recess and press the wire into the slot on the side. Replace the battery door.
Low Battery Indication Parent Unit • When the battery is low in the parent unit, the LED bar on the side of the unit will change from green to red and you will hear a series of 3 audible beeps every 5 seconds. If operated too long on a low battery, you may also experience a poor signal and the connection LED on the front of the parent unit may change from green to red and you will begin to hear a continuous audible beep from the Parent Unit.
Testing the System It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter. Test the units if you suspect they may have been damaged or have not been used for a long time. 1. If two adults are present, have one take the Parent Units to different locations, trying various volume settings, while the other speaks into the Nursery Unit. 2. If only one adult is available, place a ticking clock, radio, or other sound-producing device near the Nursery Unit to test it. 3.
Piezas de repuesto • Información sobre la garantía (EE.UU.) Registro del producto (EE.UU.) Para comprar piezas o accesorios o para obtener información sobre la garantía en los Estados Unidos, por favor comuníquese con nosotros en: www.gracobaby.com O 1-800-345-4109 Para registrar su producto Graco desde dentro de los EE.UU., visítenos en línea en www.gracobebe.com/productregistration. Actualmente no aceptamos registros de los productos de quienes viven fuera de los Estados Unidos de América.
No observar estas advertencias y las instrucciones de armado podría resultar en lesiones serias o la muerte. Este dispositivo ha sido diseñado solamente para monitorizar los sonidos de su niño. No le enviará alertas sobre las actividades silenciosas de su niño. Cuando se usa el monitor, debe proporcionar la supervisión necesaria para mantener la continua seguridad de su niño. Este producto no ha sido diseñado ni debe usarse como un monitor médico.
Instalación de las pilas - + - - + Instale la pila + Unidad para padres • La pila debe estar instada en la unidad para padres antes de que la unidad esté lista para su uso. Saque la puerta de las pilas de la unidad para padres con una llave o destornillador plano. Saque el paquete de pilas del empaquetado y enchúfelo a la parte trasera de la unidad. Ponga el paquete de pilas en el compartimiento y oprima el alambre en la ranura del costado. Vuelva a instalar la puerta de las pilas.
Indicador de pilas descargadas Unidad para padres • Cuando la pila está descargada en la Unidad para padres, la barra del diodo electroluminiscente en el costado de la unidad cambiará de verde a rojo y escuchará una serie de 3 sonidos cada 5 segundos.
9. Si la Unidad para padres todavía no puede comunicarse con la Unidad del dormitorio (el diodo electroluminiscente de conexión será de color rojo y se escuchará a la unidad), apague la Unidad para padres y la Unidad del dormitorio. Espere 10 segundos y luego oprima el botón para bajar el volumen en la Unidad para padres mientras oprime el interruptor de encendido y apagado. Cuando la unidad se encienda, escuchará un solo sonido y todas las luces indicadoras de sonido se iluminarán.
Solución de desperfectos NO INTENTE MODIFICAR LA UNIDAD. CUALQUIER MODIFICACIÓN AL TRANSMISOR Y/O RECEPTOR PUEDE CANCELAR LA AUTORIDAD DEL OPERADOR PARA USAR EL EQUIPO. Estática La mayoría de los problemas tienen simple solución. Primero, verifique que: • La electricidad esté ENCENDIDA en ambas unidades.