User's Manual

L12100
Page 3
APPLICATIONS
Typical applications of LubriSystem include the following:
• Mobile Equipment
- Front End Loaders
- Haul Trucks
- Blast Hole Drill Rigs
- Paving Equipment
• Plastic/Rubber Industrial Equipments
- Tire Presses
- Injection Molders
• Food Processing Equipment
- Peelers
- Washers
- Mixers
- Ovens
- Conveyors
- Can-making Machines
• Packaging Equipment
- Palletizers
- Stackers
- Wrappers
• Lumber Equipment
- Debarkers
- Edgers
- Slasher Decks
- Planers
- Stoker Grates
- Saw Guides
- Winders
- Presses
SYSTEM OPERATION
As shown in Figure 1, when the electic motor or solenoid-operated air valve receives a signal from the timer, or when the operator actuates
the handle, the pump is activated. The pump dispenses lubricant either into the mainline tubing which distributes the lubricant to the
manifolds, feeding each injector, or to lines supplying bearing point injectors. Each of the injectors is sized to measure and dispense the
proper amount of lubricant based on the size of the bearing. Details of the operation of each component are included in this brochure.
INTERCHANGEABLILITY
LubriSystem components are functionally interchangeable with other commonly used single-line, parallel injector systems. Air inlet and
lube outlet ports are 1/4-8 NPT, typical of most other pumps in the fi eld. Injectors have a 3/16 in tube connection as standard. An accossory
indicator/adaptor allows 1/8 in tubing to be connected to the outlet. Mounting dimensions of LubriSystem components are very close to
theose of other systems. And, if some components, there is a direct interchangeability in form and fi t as well as function.