Operation Manual

Coffee Grinder CM 95
© Gebr. Graef GmbH & Co. KG - 01
EN
11
How to programm and
grind measurements
noTe
■ The factory default setting for
cup
is 12 seconds, and for
cups is 20
seconds.
■ To reset original factory default set-
tings, press and hold the program P
button for a period of 5 seconds. All
three buttons will ash once after 1
second - continue pressing the pro-
gram P button and all three buttons
will ash three times at 5 seconds. This
will indicate the factory default set-
tings have been restored.
■ Position the group handle with grind fun-
nel positioned on top into the group hand-
le locator.
■ Flip the switch to the ‘Auto’ position.
■ On the control panel, press and hold the
program P button for a period of 1 second
- all three buttons will ash once indicating
you have activated program mode. Remo-
ve your nger from the program P button.
The program P button will stay fully illumi-
nated, while the
button and but-
tons will soften in brightness.
noTe
The programming mode can be
aborted at any stage by pressing the
program P button again.
 Select either the
cup or but-
ton to program the grind time for that
selected button. The selected button
will begin to ash, and the motor will
become activated. Ground coffee will
begin to deliver into the group handle.
 To stop the coffee grind and set your
programmed
or grind meas-
urement, re-select the
or
button that was previously selected
(this is indicated by the ashing but-
ton). The motor will be de-activated,
and the time of the selected
or
function will be stored.
noTe
Allowable program time for
and
uttons is 2 sec – 40 sec..
Cleaning
Old coffee remains in the unit can lead to
oxidation. That spoils the beverage; it can
cause an unpleasant, rancid taste. The units
should always be in optimum condition to
be able to provide optimum espresso at any
time.
imporTanT!
■ Spots and marks on the surface of the
burrs are part of the hardening pro-
cess. These marks do not affect the
performance of the grinder or the tas-
te of the coffee.
■ Ensure the unit is switched off and un-
plugged from the power outlet.
■ Clean the exterior of the unit with a soft,
moist cloth. If heavily soiled, a mild deter-
gent can be used.
■ Take off the coffee bean container. Press it
down and turn counter clockwise.
■ Take out the unused beans and put them
in an airtight container so they stay fresh.
■ Clean the coffee bean container and the
coffee container with warm water and a
little detergent.
■ After that, dry both receptacles well.
Cleaning the burrs
If the coffee grinder is used frequently (eve-
ry day), the burrs need to be cleaned every
three weeks to ensure best performance of
the coffee grinder. Regular cleaning helps
the burrs achieve consistent grinding re-
sults, which is especially important when
grinding coffee for espresso
■ Remove the coffee bean container as de-
scribed in “Cleaning”.