EN Espresso Machine Instruction Manual Siebträger-Espressomaschine ES 70 1
Vorbereitung / Preparation 1 2 POWER COFFEE STEAM 3 4 HOT WATER MANUAL 5 6 POWER 7 COFFEE STEAM HOT WATER 8 POWER COFFEE STEAM HOT WATER
Espressozubereitung / Making the espresso 1 2 3 4 5 6 7 8 POWER COFFEE STEAM HOT WATER POWER COFFEE STEAM HOT WATER
POWER COFFEE STEAM HOT WATER Drehregler Controll knob Dampf-/Heißwasserlanze mit Pannarello Steam-/ Hot water jet with pannarello Wassertank Water tank Siebträger Group handle Abtropfschale Drip tray
EN Table of content Safety instructions.......................... 4 Before the first use......................... 5 Unpacking....................................... 6 Requirements for the installation location................. 6 Using the control panel................. 6 POWER........................................... 6 STEAM............................................ 7 HOT WATER.................................... 7 Milk frothing.................................. 7 Advanced Programming Options...........
EN Safety instructions This unit complies with the statutory safety regulations. Improper use can, however, lead to personal injury and property damage. To handle the unit safely, follow the instructions below: • Check the unit for external, visible damage to the housing, the supply cord and the plug before using it. Do not put a damaged unit into operation. • Repairs are only allowed to be performed by a specialist or by the Graef customer service department.
EN • If the supply cord is damaged, it must be replaced by the manufacturer, its service or similarly qualified persons in order to avoid a hazard. • Always pull the supply cord from the electric socket using the connector plug, not the supply cord. • Do not carry the unit by the supply cord. • Never transport the unit during operation. • Do not touch the plug with moist hands. • Do not use the packing material as a toy. Danger of suffocation.
EN water (without coffee grounds) to thoroughly flush the system. Proceed as described in the „Preparing espresso“ section. Unpacking To unpack the unit, proceed as below: • Take the unit out of the carton. • Remove all pieces of the packing. • Remove any possibly extant labels on the unit. (not the rating plate).
the OFF position. EN STEAM You can froth-up milk with the STEAM function. To activate the steam function, press the „STEAM“ button. The „STEAM“ lamp flashes, „COFFEE“ and „HOT WATER“ extinguish. After a short heatingup period, the lamp stops flashing. You can now start frothing the milk. To froth up the milk, turn the rotary control to „OPEN“. After completing the process, turn the rotary control back to „OFF“ and press the „HOT WATER“ button again.
EN • Now immerse the milk frother nozzle with the Pannarello into the milk to approx. 1 cm under the surface. • Open the steam control to the limit. • Hold the milk container at a slight angle while doing so. • Lower the milk can as soon as the milk level rises.
EN should it be desired. To do this you need to follow the instructions below: • Switch off the unit. • Press the „COFFEE“ button for 3 seconds. While still holding down the „COFFEE“button briefly press the „POWER“ button and release. Release „COFFEE“button. This activates the programmability of the Espresso Temperature. The lights behind the „STEAM“ and „HOT WATER“ buttons will start flashing. Within 30 seconds press one of the flashing buttons depending on the required temperature adjustment.
EN • While still holding down the „STEAM“button briefly press the „POWER“ button and release. • Release „STEAM“button. • This activates the programmability of the Steam Temperature. • The lights behind the „COFFEE“ and „HOT WATER“ buttons will start flashing. Within 30 seconds press one of the flashing buttons depending on the required temperature adjustment.
EN • Within 30 seconds press one of the flashing buttons depending on the required temperature adjustment. • Up (+) a setting : Press „STEAM“ • Down (-) a setting : Press „COFFEE“ To save your settings press and hold down the „HOT WATER“ button for 3 seconds. A single long beep will sound to indicate your settings have been saved. Factory Reset To undo any changes made to the program you can revert back to the original factory settings.This resist ALL the programm settings back to factory settings.
EN • After you have removed the drip dish, you will find the cleaning set in the interior of the unit on the plastic. • Take out the cleaning set. • Clean the holes in the filter insert with the thin end of the cleaning pin. • Use the thick end of the cleaning pin to clean the milk frother/hot water nozzle pipe. • Then clean the pipe with a moist cloth. Descaling Just as with any unit that is operated with water, the group handle automatic machine also requires periodic descaling.
EN • Let the remaining mixture run through once more. • Remove the water tank and rinse thoroughly. • Fill the water tank again with fresh water. • Place a container under the brewing head again. • Let fresh water run through several times. • Now fill the water tank with fresh water. Customer service If your Graef unit becomes damaged, please contact your dealer or the Graef customer service department.
EN The water tank is not correctly inInsert the water tank correctly. serted. The milk froth and hot water nozClose the control. zle control is open. Empty the group handle and refill it with coffee. Make sure you do not The group handle is plugged up. press the coffee down too much and that the coffee is not ground too fine. The unit calcifies. Decalcify the unit. Brewing head screen is dirty. Clean the brewing head screen. Espresso does not have any The coffee is too old or too dry.
EN There are too few coffee grounds Fill more coffee grounds. in the group handle. Very loud pumping noise There is no water in the water tank. Fill the water tank. The water tank is not correctly inInsert the water tank correctly. serted. No steam Not enough frothing froth Coffee is too cold during The unit is calcified. Decalcify the unit. The steam nozzle is plugged up. Clean the steam nozzle. The milk is not fresh. Use fresh milk. The milk temperature is too high.
EN The unit does not work at all The unit is not connected to the Plug the plug into the electric mains. socket. The brewing head filter is plugged Clean the brewing head filter. up. The unit is calcified. The indicator lights illuminate but water does not flow through Decalcify the unit. If the unit has stood for a long time Wait and open all the nozzles once it is possible that it takes up to 8 so that the air that has collected minutes until the water flows into there can escape. the tank.
EN damages that have arisen due to improper handling and use as well as defects which have only a slight influence on the functioning or value of the unit. Furthermore, shipping damages, unless our responsibility, are excluded from warranty rights. Warranty claims are excluded for damages that arise due to repairs we or our representatives have not performed. In case of a justified complaint, we will repair or replace the defective product with a flawless product as we choose.
Deutschland Gebr. Graef GmbH & Co. KG Donnerfeld 6 59757 Arnsberg Tel: 02932-9703688 Fax: 02932-970390 service@graef.de Niederlande Första Nederland BV Kellenseweg 2a NL-4004 JD Tiel Tel: 0031 / 344 61 54 70 Fax: 0031 / 344 62 14 06 info@forsta.nl Österreich Emil Pickhart KG Hosnedlgasse 12 A-1220 Wien Tel: 0043 / 1-259 71 31 Fax: 0043 / 1-259 62 63 graef@pickhart.at Großbritannien EPE International Ltd.
Entkalkung / Decalcification 1 2 1x 3 POWER POWER 6 COFFEE STEAM HOT WATER 9 POWER STEAM HOT WATER POWER COFFEE STEAM HOT WATER POWER COFFEE STEAM HOT WATER 8 COFFEE STEAM HOT WATER 11 POWER 14 13 HOT WATER 7 POWER 10 COFFEE STEAM ca. 5 Min.
