Operation Manual

44
Espresso Machine ES 80 / ES 81
EN
important!
The unit will then automa-
tically power on and begin
heating up.
The unit will stay in pro-
gramming mode for up to
30 seconds. If you do not se-
lect a new temperature set-
ting within 30 seconds the
programm will automatically
return to the Factory Setting
and the unit will the power
on and begin heating up.
Steam Wetness or Steam
Pump Rate
The steam pump rate of this unit
has been pre-set. Modifying the
steam pump rate enables you to
make the steam wetter or dryer
and aids in the delivery of a po-
werful, dry steam - ideal for tex-
turing milk. The steam pump rate
can be modied in ow rate in-
crements up or down should it be
desired.
To do this you need to follow the
instructions below:
Press the "HOT WATER" button
for 3 seconds.
While still holding down the
"HOT WATER"button briey
press the "POWER" button and
release.
Release "HOT WATER"button.
This activates the programmabi-
lity of the steam pump rate and
to signal this, the unit will out-
put the current setting with a se-
quence fo beeps.
Beep Sequenze Setting
3 short Beeps + 3
2 short Beeps + 2
1 short Beep + 1
1 short und 1
long Beep
Factory Setting
1 long Beep - 1
2 long Beeps - 2
3 long Beeps - 3
important!
The lights behind the "COFFEE"
and "STEAM" buttons will start
ashing.
Within 30 seconds press and re-
lease one of the ashing buttons
depending on the required tem-
perature adjustment.
Up (+) a setting : Press "STEAM"
Down (-) a setting : Press "COFFEE"
important!
When you have selected a
new temperature setting the
unit will sound a sequence
of beeps to indicate the new
temperature setting.
To save your settings press and
hold down the "HOT WATER"
button for 3 seconds. A single
long beep will sound to indicate
your settings have been saved.
important!