MSDS

ManualsBrandsGraf-X Cleaner ManualsPaint1-gal. Graffiti and Paint Remover

www.getNewLook.com ! 1525 South Gladiola Street, Suite 8, Salt Lake City, UT 84104 ! 877.763.9566 ! Office: 801.886.9495 ! Fax:

801.886.9497

Section 10

STABILITY & REACTIVITY

Stability: Stable.

Hazardous Polymerization: Will not occur.

Conditions to Avoid: Freezing. Keep away from heat and open flames.

Materials to Avoid: Strong chemicals and oxidizing materials.

Hazardous Decomposition Products: Will not occur.

Section 11

TOXICOLOGICAL INFORMATION

N/A

Section 12

ECOLOGICAL INFORMATION

N/A

Section 13

DISPOSAL CONSIDERATIONS

! Use non-leaking containers, seal tightly, and label properly.

! Dispose of in accordance with applicable local, county, state, and federal guidelines.

! Do not dispose in streams, wells, lakes, rivers, oceans, or sewers.

Section 14

TRANSPORT INFORMATION

DOT Proper Shipping Name: Liquid Anti-Graffiti

DOT Hazard Class ID Number: Non-hazardous. Not required, Class 55.

Section 15

REGULATORY INFORMATION

Reportable Quantity: N/A

NFPA Rating: 0 = Insignificant, 1 = Slight, 2 = Moderate, 3 = High, 4 = Extreme

Carcinogenicity Lists: N/A

NTP: Yes

IARC Monograph: N/A

OSHA Regulated: N/A

Section 16

OTHER INFORMATION & LEGEND

IMPORTANT: The MSDS should be read before product disposal. Pass MSDS information to all persons who could be exposed to the product. The

MSDS has been prepared according to OSHA Hazard Communication Standard (29 CFR 1910.1200). To the best of our knowledge, the information

contained herein is accurate and based on sources believed to be reliable. However, since data, safety standards, and government regulations are subject

to change, NewLook International, Inc. makes no warranty, either expressed or implied, with respect to the completeness or continuing accuracy of the

information contained herein and disclaims all liability for reliance thereon. The data on this sheet is related only to this specific material. It may not be

valid for this material if used in combination with any other materials. It is the end user’s responsibility to determine suitability and completeness of this