Oxygen Regulator Instructions & Warranty Information JB0150-081, JB0150-083
Oxygen Flow Control Regulators Oxygen flow control regulators are pressure-reducing devices which lower oxygen pressure from a cylinder to levels that can be safely used by the end user. Oxygen flow control regulators are intended for the administration of oxygen to patients who need increased oxygen levels to improve their breathing conditions. In addition, some models may be used in emergency situations. In an emergency situation, be sure to contact a physician or EMS immediately.
Set-Up (H-Nut Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Before attaching the regulator to the valve, inspect the regulator and the seal to ensure that they’re in good condition, and be sure that the regulator has just one of the CGA-870 seals. Gently thread the large nut on the regulator on the connection on the cylinder valve.
Limited Lifetime Warranty Your product is warranted to be free of defects in materials and workmanship for the lifetime of the original consumer purchaser. This device was built to exacting standards and carefully inspected prior to shipment. This Limited Lifetime Warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the consumer of years of dependable service.
