User guide



PRODUCTNOTIFICATION
PNOT‐454
GSIGROUP•1004E.IllinoisSt.•Assumption,IL62510USA•888‐GSI‐BINS•Fax:800‐800‐5329
Page1of15
Date:9‐15‐11
MODELS:6x6DistributorPlatforms
PlatformClamps

Thisassemblyisdesignedtobelocatedatanyelevationontrunkingthatisneededtoprovideaccessto
otherequipment. Determineelevationofplatformsurfaceandworkfromthere.Locateallpartsrequired
forassemblybyusingthechartasshowninFigure1.

Locateallclamphalves(DSP36007),
clampbrackets(DSP36016),threadedrods (DSP36008)and
hardwaretoassembleclampsontothetrunking.Measurethedistancebetweentheclampstoassure
properlocationforsupportchannelsandkneebraceattachment.Seeclampde tailinFigure1forhardware
orientation.Attachoneclamphalftotheendofeachplatformsupport
channelusing5/8"hardware
inthetopandbottomholesofthebracket.Insertrodthroughthemiddleholeinthebracketsattached
totheplatformsupportchannel.Fastenusing5/8"nut,5/8"lockwasherandtwo(2)flatwashers.Place
bracketswithsupportchannelsattachedaroundtrunkingandfasten
inplacewithclampbracketusing
1/2"hardware.Adjustthepositionoftheinsidenutsoftherodassemblytoallowtheclampstobe
tightenedontothetrunking.

NOTE:Tightenclampsontotrunking,donotovertightenandcollapsethetrunking.Positioninsidenuts
backtotheclampan dtighten.



Figure1