Manual

29
2003 Top Dry Service School
Fill 1 Motor Overload
The thermal overload in the fill system control
box for fill system number one has tripped, indicating an
overcurrent condition. The overload must be reset
manually.
Fill 2 Motor Overload
The thermal overload in the fill system control
box for fill system number two has tripped, indicating an
overcurrent condition. The overload must be reset
manually.
Aeration Overload
The thermal overload in the fill system control
box for the aeration fan has tripped, indicating an
overcurrent condition. The overload must be reset
manually.
Grain High Limit
The grain temperature in the drying chamber is
too high. The grain temperature reached a point where
it was five degrees less than the plenum cycle setpoint.
Wet Supply Empty Press <Enter> To Dry Re-
maining Grain
This message is displayed when the start button
is pushed and grain has fallen away from the wet
supply rotary switch and there is still grain against the
drying chamber low level rotary switch. If the enter
button is pushed the dryer will restart, but the fill
system(s) will not restart.
Cannot Start Dryer Wet Supply Empty
This message is displayed when the start button
is pushed and grain has fallen away from the wet
supply rotary switch and there is no grain against the
drying chamber low level rotary switch. Grain will have
to be put into the wet supply tank or the drying chamber
to start the dryer.
Low Level Switch Exposed
This message is displayed when grain falls
away from the drying chamber low level rotary switch
after the Wet Bin Switch Delay has reached zero. If
the error is being caused due to the settling of grain
after the fans start the time on the Wet Bin Switch
Delay can be lengthened.