User guide

11. Electrical Connections
70 PNEG-1708 GSI Modular Tower Dryer
Plenum Temperature
Plenum temperature is monitored through the wiring in the conduit that runs up through the burner/blower
floor. This was referenced in burner/blower module on Page 48, when installing the floor planks in the
burner/blower module as it was necessary to cut a floor plank to fit around the conduit.
Connecting this is also done in the field by the customer. (See Figure 11I.)
Figure 11I
After installing the conduit clamps, simply route the conduit through the clamps and close them.
(See Figure 11J.)
Figure 11J
Conduit clamps