Operation Manual

38
Always disconnect the power if interruptions in power supply occur, and when electrical
parts are removed/put on, and before cleaning and maintenance of the appliance.
Repairing of electrical/technical parts may only be performed by a service electrician from
Gram Commercial or an authorised refrigeration company with knowledge of Gram’s
products.
Do not use the appliance before all coverings are installed, so that live or rotating machine
parts can not be touched.
The cabinet is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed.
The cabinet plug and wall socket should then give correct earthing. If necessary, contact
an electrician.
Make sure the appliance is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the cabinet by the START/STOP
key as there will still be voltage to some electrical parts of the cabinet..
General use
Do not block vent holes in the front panel.
Do not damage the refrigeration system parts.
During normal operation, some parts of the refrigeration system in the
compressor compartment might reach high temperatures, and could therefore
cause burns if touching these components.
Do not use electrical devices inside the cabinet.
To ensure correct and efficient air flow in the cabinet, the shaded areas must be
kept free of products. (see Fig. 9)
All products to be stored, that are not wrapped or packed, must be covered in
order to avoid unnecessary corrosion of the inner parts of the cabinet.
If any controller parameters are changed from default, this could cause that the
appliance is not functioning normally, and harmful temperatures could damage
products that are kept inside the appliance.
If the appliance is turned off, wait minimum 3 minutes before turning the
appliance on again. This is to protect the compressor from damage