Operation Manual

12
GB
11
12
Setting up and installation
Where to place the freezer
For safety reasons the freezer must not
be installed outdoors; it must be
placed in a dry room. Never place the
appliance close to sources of heat
such as cookers or radiators, and
avoid placing it in direct sunlight. The
surface on which the appliance is
placed must be plane. Do not use a
frame or similar. The small wheels
mounted at the rear of the freezer
make it easy to place it in the required
position.
The freezer can stand freely on the
floor or be built into a kitchen element
or a refrigerator element.
It is important that the appliance
stands completely level and that there
is good air circulation over, under and
around it. The freezer can be adjusted
by turning the four adjusting screws on
the plinth. After adjustment, the feet
and the two rear wheels must be in
contact with the surface on which the
appliance stands.
The illustrations show how to create
sufficient air circulation around the
cabinet. The dimensions give the
actual size of openings. The circulation
area must be at least 200 cm
2
.
Building into a kitchen
element
When building into a kitchen element
ensure that there is sufficient
ventilation around the freezer to
dissipate heat from the compressor.
The appliance can stand direct on the
floor or on its plinth. (11)
Building into a refrigerator
element
Building into a refrigerator element
follows the same principle as shown
in 11 (12).