Operation Manual

13
GB
Electrical connection
The appliance is intended for
connection to alternating current. The
connection values for voltage (V) and
frequency (Hz) are given on the
nameplate in the cabinet. Power must
be connected via a wall socket with
switch. The wall socket should be
easily accessible.
All earthing requirements stipulated by
the local electricity authority must be
observed.
The appliance plug and wall socket
should then give correct earthing. If in
doubt, contact your local supplier or an
authorised electrician.
WARNING
The flexible cord (mains lead) fitted to
this appliance has three cores for use
with a 3-pin 13-amp or 3-pin 15-amp
plug.
If a BS 1363 (13-amp) fused plug is
used, it should be fitted with a 13-amp
fuse.
IMPORTANT
The cores in this mains lead are
coloured in accordance with the
following code:
GREEN-AND-YELLOW: EARTH )
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond
with the colour markings identifying
the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW
core to the plug terminal marked „E” or
by an earth symbol, or coloured
GREEN or GREEN-AND-YELLOW.
Connect the BLUE core to the plug
terminal marked „N” or coloured
BLACK. Connect the BROWN core to
the plug terminal marked „L” or
coloured RED.
Starting up the freezer
Start the freezer by plugging into a wall
socket.
If the mains lead has been damaged, it
must be replaced with a corresponding
type supplied by Gram Domestic A/S or
a Gram Domestic service centre.
The freezer incorporates a „stand-by
function” and in the display two
horizontal lines indicate that the power
supply has been connected.
Start the freezer by pressing the start
button (1). After approx. 5
seconds, the green light emitting diode
(3) lights to indicate that the freezer is
on. The actual temperature in the
freezer is shown on the display .