Assembly Instructions

11
CONTROL PANEL FUNCTIONS
When the heat function is used for the first time, a slight odor may be present.
This is normal and should not occur again unless the heater is not used for an
extended period of time.
NOTICE
CONTROLS FUNCTION
Main Power
ON/OFF
Press ON. Power turns ON. All functions are enabled.
Press OFF. Power, flame effect, and all functions
turn off.
Flame Button Press once to turn flame ON. Press again to turn flame
OFF.
Flame +/- Press Flame (+/-) Button to desired flame brightness.
3 options. ONLY works when flame button is ON.
Back Light Press Back Light Button to desired back light color.
10 different color options.
Back Light +/- Press Back Light (+/-) Button to desired back light
brightness. 3 options. ONLY works when Back Light
button is ON.
Flame Speed Press Flame Speed Button to desired flame speed.
5 options.
Timer +/-
Press Timer (+) once to increase timer setting by ½ hour
increments. Maximum timer setting is 7½ hours.
Indicator light will illuminate. Press Timer (-) once to
decrease timer setting by 1 hour increments.
Heater Press Heater Button once, 750W (LOW HEAT) heater
turns on and the fan starts to blow warm air.
Press Heater Button again, turns on 1,500W (HIGH
HEAT) heater turns on and blows hot air. Press Heater
Button again and the heater turns OFF.
The fan will continue to blow to allow heater to cool down,
and then turns off. NOTE: The Heat Enabling Switch (on
the back of the unit) must be ON for the Heater function
to operate.
Thermostat
Control Knob
Heater must be ON either LOW or HIGH heat for the
thermostat function to operate. The heat output is
controlled by the Thermostat Control Knob. Set the
Thermostat Control Knob to the maximum position
initially. When the room reaches the desired temperature,
reduce the setting by slowly turning the thermostat knob,
counterclockwise until the heater will click and turn off.
The heater will then maintain the room temperature at the
desired level. NOTE: The Heat Enabling Switch (on the
back of the unit) must be ON for the Heater function
to operate.
ON
OFF
THERMOSTAT