Installation Guide

Passage/Privacy
Long Plate Door Hardware
Installation Instructions
Updated June 2016
Skip to Step if your door has pre-drilled bore holes.
See “Door Prep Template”
For 2-3/8”
Backset:
For 2-3/4” Backset
Threaded Privacy Pin Hole
(Privacy Only)
Door - Outside
Grandeur Long Plate Drilling Template
(Scale 1 to 1[full size])
(1) Locate the hole locations for your long plate on this template.
(FAV = Fifth Ave., GVC = Grande Victorian, PAR = Parthenon,
WIN = Windsor)
(2) Place drilling template on your door, centering the 2 1/8”
cross-bore hole. Keep template parallel with door edge.
(3) Mark the hole locations for your long plate on the door.
(4) Drill holes using a 7/64” diameter drill bit. Then go to step E on
the installation instructions.
DOOR EDGE: 2-3/4” from center of cross bore DOOR EDGE: 2-3/8” from center of cross bore DOOR EDGE: 2-3/8” from center of cross bore DOOR EDGE: 2-3/4” from center of cross bore
Refer to Drilling Template on opposite page
Door - Outside
Emergency Release Hole
(Privacy Only)
Door - Outside
Mounting Plate
Door - Outside
1
3
2
Push onto
mounting
plate
Rotate plate clockwise
to lock into holes
Emergency Release Hole
(Privacy Only)
Door - Outside
Screw in the
Privacy Pin
(Privacy Only)
Emergency Release Hole
(Privacy Only)
PK144 Rev3 06022016
For assistance call 1-844-372-6848 Monday through Friday, 7 am to 5 pm Mountain Time or visit www.GrandeurHardware.com/support