Installation Sheet

Updated January 2015

PK145 Rev.2 11152015

Updated November 2015

Rosette Door Hardware

Dummy

— For doors without a 2-1/8” cross-bore

Insert the rosette screws and

tighten until snug.

Mark the holes

2-3/4" Backset

2-3/8" Backset

Desired

Determine backset (distance between edge of door

and center of rosette.) Check other doors in the house

to determine backset.

Using a 7/64” drill bit, drill the screw

holes at least 3/4” deep.

Height of

Knob/Lever

Edge of

Door

(Measure other

doors in the house

to determine this)

PAGE 1
Rosette Door Hardware January 2015 Updated November 2015 — For doors without a 2-1/8” cross-bore Determine backset (distance between edge of door and center of rosette.) Check other doors in the house to determine backset. Dummy Mark the holes 2-3/4" Backset 2-3/8" Backset or Desired Height of Knob/Lever Edge of Door (Measure other doors in the house to determine this) Using a 7/64” drill bit, drill the screw holes at least 3/4” deep. Insert the rosette screws and tighten until snug.