Installation Sheet

Grandeur Long Plate Drilling Template
(Scale 1 to 1[full size])
(1) Locate the hole locations for your long plate on this template.
(FAV = Fifth Ave., GVC = Grande Victorian, PAR = Parthenon,
WIN = Windsor)
(2) Place drilling template on your door, centering the 2 1/8”
cross-bore hole. Keep template parallel with door edge.
(3) Mark the hole locations for your long plate on the door.
(4) Drill holes using a 7/64” diameter drill bit. Then go to step E on
the installation instructions.
DOOR EDGE: 2-3/4” from center of cross bore DOOR EDGE: 2-3/8” from center of cross bore DOOR EDGE: 2-3/8” from center of cross bore DOOR EDGE: 2-3/4” from center of cross bore