Instalation & Assembly

Long Plate Installation Instructions
Passage and Privacy
DETERMINING LOCK LOCATIONS (Handing)
With step-by-step Installation Pictograms
and Drilling Template
1. If your lock set has levers, and/or is a privacy, it
has an inside half, and an outside half. Remove
these from the box.
2. If your lock set is a passage with knobs, skip to
step 6 below, as both halves are the same.
3. Use the diagrams to the left and right to
determine if your door is left or right hand.
4. Outside levers on left hand doors point to the left
(towards the hinges.)
5. Outside levers on right hand doors point to the
right (towards the hinges.)
6. Privacy locks have holes next to the edge of the
door, opposite the hinges.
7. Hold each of your lock halves next to the outside
of the door to determine which half should be
attached on the outside.
Tools Required: Flat Blade Screwdriver & #2 Phillips Screwdriver (Not power tools)
Privacy release hole must be
next to the edge of the door!
Outside
Hinge is on the left.
Door is a Left Hand.
Hinge is on the right.
Door is a Right Hand.
Outside