User's Manual

Installation Guide
Home Automation Presence Sensor
PS410
The PS410 is a smart, presence sensor, which broadcasts its location
continuously via Bluetooth Low Energy (BLE) RF signal. Use the PS APP to
detect the BLE signals, determine its distance to the sensor location, and
communicate with the controller for approaching or leaving the sensor
location. Base on this, the controller takes the defined actions on other PS
devices, e.g. PS switch/power outlets, automatically according to the
pre-programmed rule set.
Overview & Operation
1. Battery Compartment
 Install the battery (CR2450)
2. Scan Pin/LED
Scan Pin
 Insert a small pin (e.g. paper clip) to set the PS410 to scan mode
LED
 Orange – Flashing => PS410 is in scan mode
Installation
1. Choose the location you want to detect to install the Sensor.
2. Open the battery compartment, remove the battery’s insulator, and
then close the battery compartment
3. Peel off the tape backing from the Sensor, and mount them onto the
chosen location from step 1.
Link PS410 to the Controller
Download and install the latest PS App to your mobile device, and refer to
the walk through instructions from PS App’s to add your PS410 sensor to
Controller. The main steps are:
 Operate your mobile device to enable the Bluetooth function.
 Use the PS App, set the App into the presence scan mode.
 Use PS410 sensor’s scan pin to set it to scan mode.
 The pairing process between the Controller and PS410 sensor will now
take place.
 The PS App will show the new device, PS410 is added.
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
❶
❷