Installation Guide

Y10

Y11

5.31 Remove the L08M-X support combo, take apart

and install on the sides of the AZ1 extension brace, as

shown in . Save the hardware and W14 bracket for

possible future use or hang inside as a plant hanger clip.

5.32 Insert polycarbonate sheets Y8’s and Y9’s into the

lower roof of your greenhouse. Panels may slide out

before gutters are in place. You may want to place a

piece of tape on the panel to prevent sliding as

shown in the diagram once the panels are in

place.

5.33 Slide 610 Gutters into 609’s

groove as shown in diagram . Repeat

on both sides. Note the orientation of the

gutters, the extension gutters will be at

the back and the holes should align with

gutter down spout hole see next page.

Y11

L08M-X

L08C-X

L08M-X

601B

601A

610

609

610

Gutter

Outside View

STEP FIVE

MIDDLE ASSEMBLY INSTRUCTIONS CONTINUED

AZ1

The two profiles should be flush

at ends when installed correctly.

TAPE