Installation Guide

607
601A
Y11
Y11
Y11
Y11
630
609
630
602B
602B
609
630
602B
602B
609
630
609
Y11
609
4.16 Insert Y11 panels to upper roof section then
slide the 630 into the groove of the upper 609 as
shown to hold Y11’s in place. See and . Note
that you may need to loosen the bottoms of some of
the 602B’s to slide the 630 into place as the t is
very tight. Check that all nut and bolt combos are
tightened again after installation of 630.
4.17 It is recommended to apply silicone caulk to
the exterior seams on the bottom and sides of each
panel, where panels meet the frame for water
resistance, or see the Moisture Control Kit on our
website to maintain panel clarity. The interior and
top of each panel is protected so it is recommended
that you leave them un-caulked allowing the panels
to breathe.
32
STEP FOUR
MIDDLE ASSEMBLY CONTINUED
Left Profile View Right Profile View
The two profiles should be flush
at ends when installed correctly.
The two profiles should be flush
at ends when installed correctly.