Full Product Manual

GrandPrix Two-Post Lifts 11 P/N 5900209 — Rev. D3 — Feb. 2020
Installation Checklist
Following are the steps needed to install a GP-7 Series Lift; perform them in this order.
☐ 1. Review the installation Safety Rules.
☐ 2. Plan for Electrical work.
☐ 3. Make sure you have the necessary Tools.
☐ 4. Select the installation Location.
☐ 5. Check the Clearances.
☐ 6. Review the installation Orientation.
☐ 7. Unload and Unpack the Components.
☐ 8. Install the Post Straps.
☐ 9. Put down Chalk Line Guides for the Posts.
☐ 10. About Embedment.
☐ 11. Install the Powerside and Offside Posts.
☐ 12. About the Lifting Cables.
☐ 13. Prepare the Top Trough.
☐ 14. Install the Top Trough.
☐ 15. Install the Power Unit (but do not connect it to power yet).
☐ 16. Install the Safety Assemblies and the Safety Cable.
☐ 17. Install the Trip Stop Tube.
☐ 18. Install the Microswitch and the Microswitch Cable.
☐ 19. About Fluid Contamination.
☐ 20. Install the Hydraulic Lines.
☐ 21. Connect the Lifting Cables.
☐ 22. Install the Safety Covers.
☐ 23. Install the Lift Arms.
☐ 24. Contact the Electrician.
☐ 25. Connect and prepare the Power Unit.
☐ 26. Adding Hydraulic Fluid.
☐ 27. Install the Power Disconnect Switch.
☐ 28. Install the Thermal Disconnect Switch.
☐ 29. Perform final Leveling of the Posts.
☐ 30. Torque the Anchor Bolts.
☐ 31. Lubricate the Lift.
☐ 32. Bleed the Hydraulic Cylinder.
☐ 33. Perform an Operational Test.
☐ 34. Review the Final Checklist.