Full Product Manual

GrandPrix Two-Post Lifts 15 P/N 5900209 — Rev. D3 — Feb. 2020
Installation Orientation
To determine the front of your Lift, drive a Vehicle in straight (do not back it in) and stop. The front of
the Lift is where the front of the Vehicle is.
The approach is the direction you drive a Vehicle onto the Lift. Generally the approach is from the rear
of the Lift towards the front of the Lift.
The orientation of the procedures and drawings in this manual is looking at the Lift from the rear,
towards the front, unless specified otherwise. This is the same orientation as shown in the image in the
Components section and in the drawing below.
This means that:
• The Powerside Post (which holds the Lowering Handle and the Power Unit) is on the right, the
Offside Post is on the left.
• The
Hydraulic Cylinder end of the Top Trough is on the right, above the Power Unit.
• The two angled arms are at the ‘front’ of the Lift.
• The two straight arms are at the ‘rear’ of the Lift.
The following drawing shows how to orient the Powerside and the Offside Posts.
Not necessarily to scale. Not all components shown.