Full Product Manual

GrandPrix Two-Post Lifts 17 P/N 5900209 — Rev. D3 — Feb. 2020
Checking the Safety Spring
Before standing up the Posts of the Lift, check to make sure the Safety Spring has not been knocked
out of place during transport.
The Safety Spring should be in position, as shown below.
Post removed for clarity. Not all components shown.
To determine whether or not the Safety Spring is in place, either slide the Lift Head up so that it comes
out of the Post enough so that you can see the Safety Spring and verify it is in place or take a flashlight
and shine it down through the Post to visually verify that the Safety Spring is in place.
If the Safety Spring has come loose during transport:
1. Slide the Lift Heads up until the Safety Spring is accessible.
2. Reconnect the Safety Spring in the location shown above.
3. Slide the Lift Heads back down.
Because the Lifting Cables are not in place, the Slack Safeties will engage when you move the Lift
Head back down (they are prevented from engaging during normal operation).
Manually hold the Slack Safeties so that they cannot engage as you lower the Lift Head.
Important: You
must disengage the Slack Safeties before proceeding with the installation.