Full Product Manual

GrandPrix Two-Post Lifts 26 P/N 5900209 — Rev. D3 — Feb. 2020
This drawing is looking down on the Top Trough from above.
Tip BendPak recommends installing the two Short Cables (which go on the inner sheaves)
first, then proceed to the two longer cables (which go on the outer sheaves). You can do
it any way you want, but these instructions go in that order.
3. Put the Button End of first Short Cable into position at the Tie Plate.
The following drawing is a side view of how a Short Cable gets routed over the sheaves.
4. Route the Short Cable under the bottom of the Cylinder side sheave and then over the top of it,
over the top of the Offside end sheave, and down through the hole in the bottom of the Top
Trough.
5. Do the same thing for the second short cable.
Make sure to put the Button End of the second Short Cable on the other side of the Tie Plate from
the Button End of the first Short Cable.
6. Put the Button End of the first Long Cable into position at the Tie Plate, on the outside of either of
the two Short Cables (it does not matter which one you do first).