Full Product Manual

GrandPrix Two-Post Lifts 29 P/N 5900209 — Rev. D3 — Feb. 2020
To route the Safety Cable:
1. Locate the Safety Cable.
The Safety Cable is a long, thin steel cable with a loop on one end; the other end does not have a
loop.
The loop end of the Safety Cable connects to the safety mechanism on the Offside Post; the ends
are not interchangeable.
Make sure to orient the Safety Cable so that the loop end stays on the Offside
Post side of the Lift.
2. Route the cable through the small notch in the bottom of the Top Trough, around the Offside
Safety Sheave, across the Top Trough
above the other components , around the Powerside
Safety Sheave, down through the small notch in the bottom of the Top Trough, and down to the
Powerside Safety.
3. Leave the two ends of the Safety Cable hanging over the ends of the Top Trough.
They will remain this way until the Top Trough is put into place.
⚠ CAUTION Do not step on or trip over the Safety Cable while the Top Trough remains near the
ground. It is a hazard until the Top Trough is put into position.