Full Product Manual

GrandPrix Two-Post Lifts 30 P/N 5900209 — Rev. D3 — Feb. 2020
Connecting the Hydraulic Cables
The Hydraulic Cables connect to ports on the Hydraulic Cylinder on one end and to the Hydraulic
Lines on the other end. Together, the Hydraulic Cables and Hydraulic Lines move hydraulic power to
and from the Hydraulic Cylinder.
The two Hydraulic Cables are:
• Long Hydraulic Cable. Connects to the Hydraulic In port.
• Short Hydraulic Cable. Connects to the Hydraulic Return port.
To connect the Hydraulic Cables:
1. Remove the shipping plugs from the Hydraulic In and Hydraulic Return ports on the Hydraulic
Cylinder.
2. Install a 90° Cylinder Fitting in each of those ports.
Leave the fittings facing towards the Powerside Post.
3. Connect the Long Hydraulic Cable to the Hydraulic In fitting; route the cable towards the
Powerside.
4. Connect the Short Hydraulic Cable to the Hydraulic Return fitting; route the cable towards the
Powerside.
⚠ CAUTION Do not pull on the Hydraulic Cables while the Top Trough remains near the ground.
They are going to stay where they are until the Top Trough is put into position.