Full Product Manual

GrandPrix Two-Post Lifts 34 P/N 5900209Rev. D3 Feb. 2020
To install the two Safety Assemblies:
1. For the Powerside Post, locate the Safety Assembly
with
the Safety Lock Release Handle, a
safety clevis pin, two springs, and one cotter pin (sometimes called a hairpin).
2. Put one of the springs next to the head of the safety clevis pin, then insert the safety clevis pin,
from the left, through the hole in the left welded plate, then through the Safety Assembly, and then
through the right welded plate.
3. Put the second spring on the right end of the safety clevis pin, then install the cotter pin.
The following drawing shows the components involved in installing a Safety Assembly. Note that
the procedures for the Powerside Post and the Offside Post are quite similar. The difference is that
some of the components on the Powerside Safety Assembly are slightly different from the
components on the Offside Safety Assembly.
4. For the Offside Post, locate the safety assembly
without
the Safety Lock Release Handle, a
safety clevis pin, two springs, and one cotter pin (sometimes called a hairpin).
5. Put one of the springs next to the head of the safety clevis pin, then insert the safety clevis pin,
from the left, through the hole in the left welded plate, then through the Safety Assembly, and then
through the right welded plate.
6. Put the second spring on the right end of the safety clevis pin, then install the cotter pin.