Full Product Manual

GrandPrix Two-Post Lifts 35 P/N 5900209 — Rev. D3 — Feb. 2020
The Safety Cable connects the two Safety Assemblies together.
Note: The Safety Cable should have been installed earlier. The following procedure describes how
to hook up the Safety Cable on the Offside Post and on the Powerside Post.
To connect the Safety Cable:
1. On the Offside Post, bring the loop end of the Safety Cable down through the inside of the Offside
Post.
2. Pull the Safety Cable out to the front of the Offside Post underneath the sheave under the Short
Welded Pin; make sure the Safety Cable is sitting correctly in the sheave.
3. Route it over the Short Welded Pin (you will have to remove the Rotor Clip first) and then put the
loop over the right end of the Welded Pin (above the Safety Clevis Pin); move the loop next to the
Safety Assembly, inside the Spring.
You will need to move the top of the Spring out of the way to slide the loop end of the Safety Cable
over the right end of the Welded Pin.
Make sure the top of the Spring is sitting against the Welded Pin, effectively holding the loop end of
the Safety Cable in place.
4. Replace the Rotor Clip.
The following photo shows how the Safety Cable should look on the Offside Post.
5. On the Powerside Post, screw two nuts onto the threaded end of the Welded Pin with Threads.
Make sure that one is on each side of the hole in the Welded Pin with Threads.
6. Bring the straight end of the Safety Cable down through the inside of the Powerside Post.