Full Product Manual

GrandPrix Two-Post Lifts 40 P/N 5900209 — Rev. D3 — Feb. 2020
Installing Hydraulic Lines
The two metal Hydraulic Lines run along the outside of the Powerside Post. They connect to ports on
the Power Unit on one end and to the flexible Hydraulic Hoses (in the Top Trough) on the other end.
The two flexible Hydraulic Hoses were connected to the Hydraulic Cylinder earlier in the installation.
Note: The two
metal
Hydraulic Lines look similar, but they are not the same. Make sure you orient
them correctly. If you get them backwards, they will not connect correctly to the Power Unit.
To install the two metal Hydraulic Lines:
1. Orient the two Hydraulic Lines correctly on the side of the Powerside Post (see drawing below).
At the bottom, one of the two comes out further from the Powerside Post (so that it can reach the
proper port on the Power Unit); that metal Hydraulic Line goes on the right side. The drawing
below shows the correct orientation of the two metal Hydraulic Lines.
The Flare Fittings at the top of the two metal Hydraulic Lines go
under the metal strap at the top
of the Top Trough, near the Safety Cable. Make sure the two metal Hydraulic Lines do not interfere
with the Safety Cable.