Full Product Manual

GrandPrix Two-Post Lifts 57 P/N 5900209 — Rev. D3 — Feb. 2020
Raising the Lift
This section describes how to raise a Vehicle on the Lift.
⚠ WARNING: Never raise a Vehicle whose weight exceeds the rated capacity of the Lift. Do not
leave the controls until the Lift is engaged on its Safety Locks.
To raise a Vehicle:
1. Make sure the Lift Arms are on the ground in their full drive-thru position.
2. Drive the Vehicle in.
⚠ CAUTION When driving a Vehicle in, keep to the middle of the area between the Posts. If you
hit any portion of the Lift, you could damage the Vehicle and/or the Lift.
3. When you are satisfied with the location of the Vehicle, put it in park, put on the parking brake, and
turn off the motor.
If the Vehicle is a manual transmission, put it into first gear before turning off the motor.
4. Get out of the Vehicle; open the doors carefully to avoid banging them on the Lift.
5. Adjust the Lift Arms under the Vehicle so that the Lift Pads are directly under the manufacturer
recommended Lifting Points for that specific Vehicle.
If necessary, use the included extensions to get the Lift Pads close under the Lifting Points.
6. Push in and hold the Up Pushbutton (on the Power Unit near the top).
7. Release the Up Pushbutton when the Lift Pads are
just under the Lifting Points.