Owner's manual

Grandstream Networks, Inc. BT-200 User Manual Page 25 of 35
Firmware 1.1.1.14 Last Updated: 12/2006
Quick IP Call
Mode
Dial an IP address under the same LAN segment by simply pressing the last octet
in the IP address.
In the Advanced Settings page the option "Use Quick IP-call mode", is set to No
by default. When this option is set to YES, and #XXX is dialed, where X is 0-9 and
XXX <=255, phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc
comes from the local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK).
eg.
192.168.0.2 calling 192.168.0.3 just dial #3 follow by SEND or #
192.168.0.2 calling 192.168.0.23 just dial #23 follow by SEND or #
192.168.0.2 calling 192.168.0.123 just dial #123 follow by SEND or #
192.168.0.2 dial #3 and #03 and #003 has same effect --> call 192.168.0.3
NOTE: If you have a SIP Server configured, Direct IP-IP call will still work. However,
if you are using STUN, Direct IP-IP call will also use STUN.
Lock keypad
update
If this parameter is set to “Yes”, the configuration updates via keypad for Menu Item
7, 9, 12 are disabled.
TABLE 11: INDIVIDUAL SETTINGS DEFINITIONS
Account Active
This field indicates whether the account is active or not. The default value for
the primary account Account 1 is Yes. The default values for the other three
accounts are No.
Account Name
A name to identify an account which will be displayed in LCD.
SIP Server
SIP Server’s IP address or Domain name provided by VoIP service provider.
Outbound Proxy
IP address or Domain name of Outbound Proxy, or Media Gateway, or
Session Border Controller. Used by BT–200 for firewall or NAT penetration in
different network environment. If symmetric NAT is detected, STUN will not
work and ONLY outbound proxy can provide solution for it.
SIP User ID
User account information, provided by VoIP service provider (ITSP), usually
has the form of digit similar to phone number or actually a phone number.
Authenticate ID
SIP service subscriber’s Authenticate ID used for authentication. Can be
identical to or different from SIP User ID.
Authenticate
Password
SIP service subscriber’s account password for BT–200 to register to (SIP)
servers of ITSP.
Name
SIP service subscriber’s name which will be used for Caller ID display.
Use DNS SRV:
Default is No. If set to Yes the client will use DNS SRV to look up server.