User's Manual

P a g e | 14
DP760 User Manual
Connecting via PoE
To connect the DP760 DECT Repeater using PoE, you need to connect the Ethernet cable provided (or
3rd party network cable) between the Network Socket on the repeater station to Ethernet port of your PoE
switch/hub.
DP760 Implementation Architecture
The DP750 Base Station can support up to 5 DP760 DECT Repeater stations to extend the coverage area
of the base in all directions, including through floors and ceilings using star or daisy chain configuration as
displayed on the following diagrams. The repeater determines automatically if is better to utilize star or
daisy chain configuration depending on its deployment location.
When a repeater powers on, it searches for signals from the base and any other repeaters registered to the
same base. The repeater will automatically connect to the strongest available signal.
The base can hand-off calls to the repeaters as the user moves from one coverage area to another. When
connected to the repeater, the DP720 handsets operate as it’s connected to the base, and the hand-off
from the base to the repeater can be completely invisible to the end user, even during an active call.
Note: DP760 can relay up to 2 concurrent calls in star configuration and 1 concurrent call in daisy chain
configuration.
Figure 3: Connecting the Repeater Station