User's Manual

P a g e | 31
DP760 User Manual
DP760 DECT REPEATER ASSOCIATION WITH DP750
Step 1: Enabling Repeater Mode On DP750
Before associating the DP760 DECT Repeater to your DP750 Base Station, you should firstly enable the
repeater mode on your base station.
Please refer following steps to enable the repeater mode on the DP750 base station:
1. Access the Web GUI of your DP750 using the admin’s username and password. (Default username
and password is: admin/admin).
2. Navigate to DECT > General Settings and set Enable Repeater Mode to “Yes “.
Figure 10: Enable Repeater Mode
3. Press Save and Apply, then reboot the base to apply the new settings.
Step 2: DP760 DECT Repeater Association
After enabling the repeater mode on DP750 Base Station, you can easily associate it with your DP760
DECT Repeater using two methods:
 Auto Association
 Manual Association
Option 1: Auto Association
To auto associate your DP760 DECT Repeater with DP750 Base Station:
1. Power on the DP760 DECT Repeater,
2. After the DP760 finish booting, the association LED will be blinking to indicate that the repeater
is searching for nearby base stations.
Note: If all the LEDs remain on, it indicates that the DP760 Repeater has successfully associated with
a DP750 Base and ready for use. (Please refer to DP760 Dissociation).