User's Manual
Table Of Contents
- Users Manual DP760
- DOCUMENT PURPOSE
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- GETTING STARTED
- CONFIGURATION GUIDE
- DP760 DECT REPEATER ASSOCIATION WITH DP750
- DP760 DECT REPEATER DISSOCIATION
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING THE DP760
- Users Manual DP760 FCC
P a g e | 32
DP760 User Manual
3. Open subscription on your DP750 Base Station using one of following methods:
Rebooting the Base station.
Long press on page/subscribe button on the back panel of DP750 for 7 seconds.
Access DP750 Web GUI and press subscribe button .
4. The DP760 DECT Repeater will automatically pair to DP750. Upon successful association with the
DP750 Base station all LEDs will turn ON and the repeater status will be updated as following.
Figure 11: Repeater Associated Status
Note: For auto association, the option “Use manually configured RFPI “ under DP760 Web GUI should be
disabled (by default disabled).
Option 2: Manual Association
To manually associate your DP760 DECT Repeater to your DP750 Base Station:
1. Access the Web GUI of your DP760 using the admin’s username and password. (Default username
and password is: admin/admin).
2. Navigate to DECT > General Settings and set Use Manually Configured RFPI to “Yes “.
3. On Manually Configured Base RFPI field, configure your DP750 Base Station RFPI address.
Note: The RFPI Address of your DP750 Base Station is available under the Web GUI > Status > DECT
Status > Base DECT RFPI Address.