User's Manual
Table Of Contents
- Users Manual DP760
- DOCUMENT PURPOSE
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- GETTING STARTED
- CONFIGURATION GUIDE
- DP760 DECT REPEATER ASSOCIATION WITH DP750
- DP760 DECT REPEATER DISSOCIATION
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING THE DP760
- Users Manual DP760 FCC
P a g e | 33
DP760 User Manual
4. Click Save and Apply to confirm the new settings.
5. Open subscription on your DP750 Base Station using one of following methods:
Rebooting the Base station
Long press on page/subscribe button on the back panel of DP750 for 7 seconds
Access DP750 Web GUI and press subscribe button .
6. The DP760 DECT Repeater will automatically pair to DP750. If the association is correctly associated,
all the LEDs will remain solid on and the repeater status will be updated as following.
Figure 12: Repeater Associated Status
Note: Make sure that Repeater Mode is enabled on your DP750 Base Station.
Option 3 : Repeater Management Mode On DP750
Enabling Repeater Management Mode
The following steps illustrate how to enable and use the “Repeater Management” mode on DP750:
1. Access DP750 Web GUI. (Default username and password are: admin/admin).
2. Navigate to DECT > General Settings and set Enable Repeater Management to “Yes“.
3. Press Save and Apply, then reboot the unit to apply the new settings.