Grandstream Networks, Inc. 1297 Beacon Street, 2nd Floor Brookline, MA 02446. USA Tel : +1 (617) 566 – 9300 Fax: +1 (617) 249 – 1987 www.grandstream.com For Warranty and RMA information, please visit www.grandstream.
EN PRECAUTIONS: The GXP2120/2110 is not pre-configured to support or carry emergency calls to any type of hospital, law enforcement agency, medical care unit (“Emergency Service(s)”) or any other kind of Emergency Service. You must make additional arrangements to access Emergency Services. It is Your responsibility to purchase SIP-compliant Internet telephone service, properly configure the GXP2120/2110 to use that service, and periodically test your configuration to confirm that it works as You expect.
Installing the phone (Phone Stand) : PHONE SETUP: Wall Mount Holes are available For installing the phone on the table with the phone stand, attach the phone stand to the bottom of the phone where there is a slot for the phone stand. (Upper half, bottom part). CONNECTING THE PHONE: Refer to the illustration below when following the setup instructions .
Tips For Using the Keypad: Message Waiting Indicator Line Keys Message Navigation Keys Menu/OK Key 3. Press down arrow button to Status and press MENU button to see IP address. 4. Type the phone’s IP address in your PC browser. (See figure below) 5. The default administrator password is “admin”; the default end-user password is “123”.
Installing the Extension Module for the GXP2120/2110 Extension Stand Setup Power Extension Connector Port 1. Attach the stand to the extension module 2. Connect the extension module with the phone main body by sliding it into the bracket on the side of the phone. 3. Connect the Extension module to the GXP main body using the cable provided. 4. Connect the extension module to an electrical power outlet using the universal power adapter provided. Configuration 1.
PRECAUTIONS: INSTALLATION DU TELEPHONE: Les trous pour le montage sur le mur sont disponibles ALERTE: Veuillez ne pas redémarrer le GXP2120/2110 lorsque les voyants clignotent durant le démarrage du système ou la mise à jour du firmware. Ca peut corrompre l’image du firmware et causer un dysfonctionnement de l’unité. ALERTE: N’utilisez que le boîtier d’alimentation fourni dans le pack GXP2120/2110. L’utilisation d’un autre boîtier d’alimentation non qualifié peut endommager l’unité.
Installation du téléphone (Positionneur téléphonique): “Pour installer le téléphone sur la table avec le positionneur du téléphone, joignez ce dernier à la base du téléphone où il y a une fente. (Moitié supérieure, une partie du bas). Conseils d’utilisation du clavier : Indicateur du message en attente Boutons des lignes Message Boutons de navigation Bouton Menu/OK CONNECTER LE TELEPHONE: Reportez-vous à l’illustration ci-dessous en suivant les instructions d’installation.
3. Appuyez sur le bouton «Flèche vers le bas » jusqu’a “Statut” et appuyez sur la touche MENU pour afficher l’adresse IP. 4. Tapez l’adresse IP du téléphone dans votre navigateur PC. 5. Le mot de passe d’administrateur par défaut est «admin», le mot de passe utilisateur par défaut est “123”. Configurer le GXP2120/2110 en utilisant le Clavier: Positionneur de l’extension 1. Assurez-vous que le téléphone est libre INSTALLATION 2.
ES PRECAUCIONES: El GXP2120/2110 no esta pre-configurado para soportar o realizar llamadas de emergencia a ningún tipo de hospital, agencia policial, unidad de cuidado medico o cualquier otro servicio de emergencia. Es su responsabilidad contratar un servicio de telefonía de Internet compatible con el protocolo SIP, configurar el GXP2120/2110 para utilizar dicho servicio y periódicamente probar esta configuración para confirmar que este trabajando como usted espera.
INSTALACIÓN DEL TELÉFONO: Disponibilidad de orificios para montura de pared. Instalando el teléfono (Sobre escritorio) : instalar el teléfono sobre un escritorio, utilice el soporte del teléfono y Para colóquelo en la parte inferior del teléfono donde se encuentra la ranura para el soporte. CONECTANDO EL TELÉFONO: Haga referencia a la figura de mas abajo al seguir las instrucciones.
Sugerencias para Usar el Teclado: Indicador de Mensaje en Espera Teclas de Líneas Mensaje 3. Navegue hasta la opción de “Status” y presione MENU para descubrir la dirección IP del teléfono. 4. Ingrese la dirección IP del teléfono en su navegador. 5. La clave de administrador por defecto es “admin”; para usuarios finales es “123”.
Installazione del modulo di estensione per GXP2120/2110 Estante de la Alimentación Puerto Conector del Extensión Modulo de Extensión Instalación 1. Adhiera el estante al modulo de extensión. 2. Conecte el modulo de extensión al teléfono deslizándolo por la ranura lateral. 3. Conecte el modulo de extensión al GXP utilizando el cable incluido en el paquete. 4. Conecte el modulo de extensión a un enchufe de electricidad utilizando la fuente de alimentación incluida en el paquete. Configuración 1.
VORSICHTSMAßNAHMEN: TELEFON-SETUP: Wandhalterungslöcher sind vorhanden WARNUNG: Schalten Sie bitte das GXP2120/2110 NICHT aus und wieder ein, wenn die LED-Lichter während der Systemaufladung oder der FirmwareAktualisierung blinken. Die Firmware-Bilder können dadurch fehlerhaft werden, sowie die Störfunktionen des Geräts werden dadurch ermittelt. WARNUNG Verwenden Sie nur den im GXP2120/2110 Paket eingeschlossenen Netzadapter.
Telefoninstallation (Telefonstandplatz): Tipps für die Tastaturanwendung: Für die Installation des Telefons auf den Tisch mit dem Telefonstandplatz, bringen Sie den Telefonstandplatz an der Unterseite des Telefons an, in dem es einen Steckplatz für den Telefonstandplatz gibt. (Die obere Hälfte, der Unterteil).
3. Drücken Sie den Pfeilknopf “Unten” zum “Status” und den MENÜKNOPF, um die IP-Adresse zu sehen. 4. Tippen Sie die IP-Adresse des Telefons in Ihren PC-Browser. 5. Das Standardkennwort des Administrators ist “admin”; das Standardkennwort des Anwenders ist “123”. Konfigurieren Sie das GXP2120/2110, unter Verwendung von der Tastatur: Erweiterungsstand 1. Stellen Sie sicher, dass das Telefon nicht in Betrieb ist. Setup 2.
IT GXP2120/2110 non è preconfigurato per supportare o effettuare chiamate di emergenza a qualsiasi tipo di ospedale, struttura giudiziaria, unità di assistenza medica (“Servizi di emergenza”) o a qualsiasi altro tipo di servizio di emergenza. È necessario effettuare accordi supplementari per accedere ai Servizi di emergenza.
Installazione del telefono (supporto telefono): MONTAGGIO TELEFONO: Fori per montaggio a parete disponibili Per installare il telefono sul tavolo con il supporto telefono, fissare il supporto alla base del telefono dove si trova un alloggiamento per tale supporto. (metà superiore, parte inferiore).
Consigli per l’uso del tastierino: Messaggio Indicatore in attesa Tasti linea Messaggio Tasti di navigazione 3. Premere la freccia “giù” per portarsi su “Stato” e premere il pulsante MENU per visualizzare l’indirizzo IP. 4. Digitare l’indirizzo IP del telefono nel browser del vostro PC. 5. La password amministratore predefinita è ”admin”; la password predefinita per l’utente finale è “123”.
Installazione del modulo di estensione per GXP2120/2110 Supporto Alimentazione Porta connettore estensione espansione Impostazione 1. Collegare il supporto al modulo di estensione 2. Collegare il modulo di estensione al case principale del telefono facendolo scorrere nella staffa sul lato del telefono. 3. Collegare il modulo di estensione al case principale del telefono GXP usando il cavo in dotazione. 4.
ÖNLEMLER: TELEFON KURULUMU: Duvar Monte Delikleri Mevcuttur UYARI: Lütfen sistem başlatıldığı ya da donanım yazılımı güncellendiği sırada LED ışıkları yanıp sönerken GXP2120/2110 birimini yeniden BAŞLATMAYINIZ. Donanım yazılımı kopyalarını bozabilir ve birimin arızalanmasına sebep olabilirsiniz. UYARI: Sadece GXP2120/2110 ambalajından çıkan güç adaptörünü kullanınız. Alternatif niteliksiz güç adaptörlerinin kullanımı birimde olası hasara sebep olabilir.
Telefon Kurulumu (Telefon Standı): Tuş Takımını Kullanımı için İpuçları: Telefonu masaya telefon standı ile kurmak için, telefonun altında bulunan telefon standı için boşluk olan yere telefon standını takın. (Üst yarım, alt parça). Bekleyen İleti Göstergesi Hat Tuşları TELEFONUN BAĞLANMASI: İleti Navigasyon Tuşları Menü/OK (TAMAM) Tuşu Kurulum talimatlarını takip ederken aşağıdaki resme bakınız.
3. “Durum” için “aşağı” ok düğmesine basın ve IP adresini görmek için MENÜ düğmesine basın. 4. PC tarayıcınıza, telefonunuzun IP adresini girin. 5. Varsayılan yönetici şifresi “admin” ; varsayılan son kullanıcı şifresi “123” olmaktadır. Tuş Takımını Kullanarak GXP2120/2110 yapılandırılması: 1. Telefonun kullanımda olmadığından emin olun. 2. Telefonu yapılandırmak için tuş takımı MENÜ seçeneğine erişmek için “MENÜ” düğmesine basın. 3.