User's Manual

GSC36XX Series User Manual
Version 1.0.1.3
P a g e | 32
Table 9: SIP Account Basic & Advanced Settings
SIP Basic Settings
Account Active
This field indicates whether the account is active.
Default setting is “Yes”.
Account Name
Configures the SIP account name used for identification.
SIP Server
Configures the FQDN or IP of the SIP server from VoIP service provider or
local IPPBX.
Outbound Proxy
Configures the IP address or the domain name of the outbound proxy,
media gateway, or session border controller. It is used by the GSC for
firewall or NAT penetration in different network environments.
If a symmetric NAT is detected, STUN will not work and only an outbound
proxy can provide a solution.
Backup Outbound Proxy
Configures the backup outbound proxy to be used when the “Outbound
Proxy” registration fails. By default, this field is left empty.
DNS Mode
Configure which DNS mode will be used to translate the SIP Server FQDN
(Default value is A Record):
• A Record.
• SRV.
• NAPTR/SRV.
SIP User ID
Configures the SIP username or telephone number from ITSP.
Note: Letters, digits and special characters including @ are supported.
Authenticate ID
Configures the Authenticate ID used by SIP proxy.
Password
Sets the Authenticate password used by SIP proxy.
Note: For security reasons, the SIP password is invisible on the web UI.
TEL URI
Select “User=Phone” or “Enabled” from the dropdown list.
If the SIP account has an assigned PSTN telephone number, this field
should be set to "User=Phone". Then a "User=Phone" parameter will be
attached to the Request-Line and "TO" header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead of
"SIP:" in the SIP request. The default setting is "Disable".
SIP Advanced Settings
Registration Expiration
(m)
Sets the registration expiration time.
Default setting is 60 minutes. Valid range is from 1 to 64800 minutes.
Re-register before
Expiration (s)
Specifies the time frequency (in seconds) that the GSC36XX sends re-
registration request before the Register Expiration. The default value is 0.
Range is from 0-64800 seconds.