User's Manual Part 1

Firmware Version 1.0.0.X
GVC3202 User Guide
Page
49
of
117
DIRECT IP CALL
Direct IP Call allows GVC3202 and another VoIP device to talk to each other in an ad-hoc fashion without
a SIP proxy. Direct IP calls can be made if:

Both GVC3202 and VoIP phone have public IP addresses
Or
 Both GVC3202 and VoIP phone are under the same LAN / VPN using private or public IP addresses
Or

NAT is disabled or GVC3202 NAT is disabled.
Both devices can be connected through a router using public or private IP addresses (with necessary port
forwarding or DMZ).
To make a direct IP call, please follow the steps below:
1. Access the dial screen on GVC3202.
2. Press the red shortcut key on the remote control to bring up call mode setting screen, set the mode
to "IP Call".
3. Input the target IP address. For example, if the target IP address is 192.168.124.123 and the port is
5062, input the following:
192*168*124*123#5062
The * key represents the dot (.) and the # key represents the colon (:).
4. Press the yellow shortcut key on the remote control to select "Audio Call" or "Video Call".
5. Press
on the remote control to
dial out.
PAGING/INTERCOM
Before placing paging/intercom, please make sure the callee has paging/intercom enabled so that it can
answer the paging/intercom call automatically. To make paging/intercom call:
1. Access the dial screen on GVC3202.
2. Press the red shortcut key on the remote control to bring up call mode setting screen, set the mode
to "Paging/Intercom".
3. Enter the number to dial.
4. Press the yellow shortcut key on the remote control to select "Audio Call" or "Video Call".