User's Manual Part 2

Firmware Version 1.0.0.X
GVC3202 User Guide
Page
80
of
117
Figure 42: LDAP Contacts Interface
LDAP SETTINGS
Before starting using LDAP on GVC3202, the users must configure the LDAP settings first. Press the
Blue shortcut key on the GVC3202 remote control to access LDAP settings, or the users can configure it
under GVC3202 web UI->Contacts->LDAP page.
Table 20: GVC3202 LDAP Settings Parameters
Connection Mode
It is used to select which protocol will be used for LDAP searching,
LDAP or LDAPS.
Server Address
It is used to configure the URI of the LDAP (Lightweight Directory
Access Protocol) server.
Port
It is used to configure the LDAP server port. The default LDAP port
number is 389.
Base DN
It is used to configure the LDAP search base. This is the location in the
directory where the search is requested to begin.
Example:
dc=grandstream, dc=com
ou=Boston, dc=grandstream, dc=com
User Name
It is used to configure the bind "Username" for querying LDAP servers.
Some LDAP servers allow anonymous binds in which case the setting
can be left blank.