User's Manual

Firmware Version 1.0.0.X
GVC3200 User Guide
Page
43
of
86
5. Press
on the remote control
to dial out.
ANSWERING A CALL
SINGLE INCOMING CALL
When the device is in idle and there is an incoming video call, the device will show the call screen as
below. Select “Video Answer” to answer the call with both video and audio, “Audio Answer” to answer the
call with audio only, or "End" to reject the call using the remote control navigation keys.
MULTIPLE CALLS/CALL WAITING
When there is an incoming call during an active call, users will hear a call waiting tone with the LCD
displaying the caller name and ID for the incoming call.
Figure 21 GVC3200 Multiple Incoming Calls
Similar to single incoming call, users could select “Audio” to answer with audio only, “Video” to answer
with video and audio, or “End” to reject the call using remote control navigation keys.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
By default, answering a call during an active call will automatically add this party into the conference. To
answer the call separately without establishing the conference, users could log in web UI->Settings->Call
Settings to select “Disable Conference”.
--------------------------------------------------------------------------------------------------------------------------------------------
SWITCHING LINES DUING CALL
When there are multiple calls on the GVC3200, there could be only one line in talking status while the
others will be put on hold. The users can use the Left/Right buttons on the remote control to switch
between the call. Unhold the call after selecting the line and then the users can talk using this line.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
By default, answering a call during an active call will automatically add this party into the conference. To
answer the call separately without establishing the conference, users need to log in web UI->Settings-
>Call Settings to select “Disable Conference”.