User's Manual

GVR3550 USER MANUAL

Grandstream Networks, Inc. GVR3550 User Manual Page 25 of 76

Firmware Version 1.0.0.0 Last Updated: 10/2013

LOCAL OPERATIONS

In this chapter, we take using the mouse as an example.

USING THE WIZARD（TBD）

When the unit is enabled, users could use the wizard for basic configuration when once start the GVR3550 to

make it work properly.

1. Check the display resolution. Please check the highest resolution the connected monitor supports before

selecting the resolution, make sure the highest resolution you select is no higher than the parameters the

monitor supports.

2. Confirm whether to enable the wizard the next time boot up the unit.

3. Permission authentication.

4. Time configuration. Set Time Zone, Date Format, System Time.

5. Network configuration .Set network parameters like IP Address, Subnet Mask and Gateway.

6. HDD Initialization.

7. Record configuration.

8. Save the changes and return to the wizard page to confirm finishing the setting.

The factory default username is “admin”, the password is “admin”. Users would be required to login again if

timeout without operations on the page. Please change the password after login without delay.

After entering the GVR3550 local interface, it would display the live view interface as shown in figure 13

below.Users could click right mouse and then select any item in a pop-up menu to bring up the GVR3550

Figure 13: GVR3550 Live View Page---Right-click Menu

Figure 14: GVR3550 Local Login Page

LOCAL PREVIEW

The GVR3550 would directly display Live Preview after boot up, users could check the preview screen

without login but unable to make any operations. Users could only make basic view operations and other

setups after logged in.