User's Manual

GVR3550/GVR3552 User Manual Page 40 of 125
Manual
Recording
The camera is in manual record mode.
Capture
Capture preview screenshots. The external storage devices like USB
need to be connected first and users should configure the save path.
Mute/Unmute
When the volume in on, if the remote camera is installed with audio input
device, users could listen in to the remote party.
Start /Stop
Intercom
When the intercom in on, if the remote camera is installed with audio
output device, users could speak to the remote camera via local audio
input device.
PTZ Control
Click to enable PTZ control to configure PTZ preset, patrol and pattern.
Switch to Full
Screen
Switch the current screen to full screen, or click to exit full screen.
Instant
Playback
Playback the video in preset time. It will prompt "The selected camera
has no video "if has no existing recording. Users could set the preset
time in Basic System Settings chapter.
Image Config
Enter the corresponding page to adjust the current window image.
Encoding
Config
Enter the corresponding page to configure camera encoding
parameters.
Digital Zoom
Only available when in fullscreen mode.
NOTE:
Ø Start intercom will open sound of the camera the same time. Close the intercom
to go back to its previous status.
Ø If one camera has opened sound or enabled intercom, if you want to open sound
or start intercom of the second camera, turn off the previous camera first. If you
close sound or disable intercom of the second camera, the first camera will not
go back to the previous status.
Ø If one camera has opened sound or enabled intercom, you can open sound of the
second camera and the sound of the first camera will be closed while its
intercom is still on.
IMAGE CONFIG
Click on the image config button to bring up the dialogue box as shown in figure 18. Users could
adjust brightness, contrast, saturation and hue by clicking the corresponding Plus/Minus icon or click on
button to access the editing mode. Press the Reset button to restore defaults.