User's Manual

FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipmen
t complies with FCC radiation exposure limits set forth for an uncontrolled environment .This
equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
This tra
n
smitter mu
st not be co-l
ocated or operating in conjunction with any other antenna or transmitter.

ISEDC Warning
T
his device complies
with
Innovation, Science, and Economic Development Canada
licence-exempt RSS standard(s). Operation is subj
ect
to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Leprésentappareilestconf
ormeauxCNRd'Innovation,SciencesetDéveloppement
économiqueCanada applicablesauxappareilsradioexemptsde
licence.L'exploitationestautoriséeauxdeuxconditionssuivantes:
(1)l'appareilnedoitpasproduiredebrouillage,et
(2)l'utilisateurdel'appareildoitacceptertoutbrouillageradioélectriquesubi,même
silebrouillageestsusceptibled'encompromettrelefonctionnement.
Cet équipement est conforme aux ISED RF limi
tes d'exposition aux radiations dans un
environnement non contrôlé. Cet émetteur ne doit pas être situé ou opérant en conjonction avec
une autre antenne ou émetteur.
ISEDC RF exposure statement :
Cet équipement est conforme aux ISEDC RF limites d'exposition aux radiations dans un
environnement non contrôlé. Cet émetteur ne doit pas être situé ou opérant en conjonction avec
une autre antenne ou émetteur.
This equipment complies with IS('& radiation exposure
limits set forth for an uncontrolled environment .This
equipm
ent sh
ould be in
stall
ed and operated with minimum distance 20cm between the radiator& your body.
This transmitter must not be co-l
ocated or operating in conjunction with any other antenna or transmitter.