Quick Start Guide

~1~
~2~
OVERVIEW
This WiFi long range access point is designed to provide extended coverage support. Ideal
for outdoor WiFi solutions thanks to its waterproof casing and heat resistant technology.
The GWN7600LR comes equipped with dual-band 2x2:2 MU-MIMO with beam-forming
technology and a sophisticated antenna design for maximum network throughput and
extended WiFi coverage range of up to 300 meters. To ensure easy installation and
management, the GWN7600LR uses a controller-less distributed network management design
and an embeded controller within the product’s web user interface. This allows each access
point to manage a network of up to 30 GWN76xx series APs independently without
needing separate controller hardware/software and without a single point-of-failure. Its easy
installation and management features packed with extra coverage support and advanced
performance features make the GWN7600LR an ideal enterprise AP for mid-size wireless
network deployments.
1 x GWN7600LR Access Point
1 x Quick Installation Guide
1 x GPL Statement
4 x Screw (PM8 x 115)
4 x Locknut
4 x Screws and Anchors
EN
1 x Base Bracket
PACKAGE CONTENTS
2 x Assembled Screw
1 x Cover Bracket
GWN7600LR PORTS
Port Description
NET/POE Ethernet RJ45 port (10/100/1000Mbps) supporting PoE.
NET Ethernet RJ45 port (10/100/1000Mbps) to your router or another
GWN76xx.
RESET Factory reset button. Press for 7 seconds to reset factory default
settings.
POWERING AND CONNECTING THE GWN7600LR
Network Port
RJ45 Ethernet Cable to
power over Ethernet (PoE)
Switch
● Do not attempt to open, disassemble, or modify the device.
● Do not expose this device to temperatures out the range of -30 °C to 60 °C for operating
and -30°C to 70°C for storage
● Do not expose the GWN7600LR to environments outside of the following humidity range:
5-95% RH (non-condensing).
● Do not power cycle your GWN7600LR during system boot up or rmware upgrade. You
may corrupt rmware images and cause the unit to malfunction.
PRECAUTIONS
GWN7600LR can be powered on via PoE switch using following steps:
Step 1:
Plug a RJ45 Ethernet cable into the network port of the GWN7600LR.
Step 2:
Plug the other end into the uplink port of the power over Ethernet (PoE) switch.