Quick Installation Guide

~1~
~2~
OVERVIEW
This long range Wi-Fi access point is designed to provide extended
coverage support and is ideal for outdoor Wi-Fi solutions thanks to its
waterproof casing and heat resistant technology. The GWN7630LR comes
equipped with dual-band 4x4:4 MU-MIMO technology and a sophisticated
antenna design for maximum network throughput and extended Wi-
Fi coverage range of up to 300 meters. To ensure easy installation
and management, the GWN7630LR uses a controller-less distributed
network management design in which the controller is embedded within
the product’s web user interface. The GWN7630LR is also supported by
GWN.Cloud, Grandstream’s free cloud Wi-Fi management platform. It is
the ideal Wi-Fi AP for voice-over-Wi-Fi deployments and o󰀨ers a seamless
connection with Grandstream’s Wi-Fi-capable IP phones. With support
for advanced QoS, low-latency real-time applications, mesh networks,
captive portals, 200+ concurrent clients per AP and dual Gigabit network
ports with PoE/PoE+, the GWN7630LR is an ideal Wi-Fi access point for
medium wireless network deployments with medium-to-high user density.
PACKAGE CONTENTS
GWN7630LR PORTS
POWERING AND CONNECTING THE GWN7630LR
PRECAUTIONS
• Do not attempt to open, disassemble, or modify the device.
• Do not expose this device to temperatures outside range of -30 °C to
60 °C for operating and -30 °C to 70 °C for storage.
• Do not expose the GWN7630LR to environments outside of the
following humidity range: 5-95% RH (non-condensing).
• Do not power cycle your GWN7630LR access point during system
boot up or firmware upgrade. You may corrupt firmware images and
cause the unit to malfunction.
GWN7630LR can be powered on using PoE/PoE+ switch using
following steps:
Step 1: Plug a RJ45 Ethernet cable into the network port of
GWN7630LR.
EN
1x Base
Bracket
6x Screws
(PA 3.5 x 33)
4x Screws
(PM 3.0 x 7)
Port Description
NET/POE Ethernet RJ45 port (10/100/1000Mbps) supporting
PoE/PoE+.
NET Ethernet RJ45 port (10/100/1000Mbps) to your router
or another GWN76xx.
RESET Factory reset button.
Press for 7 seconds to reset factory default settings.
Network Port
RJ45 Ethernet Cable
to power over Ethernet
(PoE/PoE+) Switch
Step 2: Plug the other end into the uplink port of the power over Ethernet
(PoE/PoE+) switch.
GWN7630LR can be mounted on the wall or on a metal bar, Please
refer to the following steps for the appropriate installation.
6x Screw
Anchors
4x Antennas
GWN7630LR
Access point
2x Metal
Straps
1x Quick Installation
Guide
HARDWARE INSTALLATION